Network Setup Screen [Network]; Network - Panasonic AW-HR140EJ Operating Instructions Manual

Web screen configurations (continued)
Refresh interval
Select the frame rate.
This is enabled only when [Stream Type] is set to [JPEG(1)],
[JPEG(2)], or [JPEG(3)].
Setting value:
For 59.94Hz:
1fps / 2fps / 3fps / 5fps / 6fps
For 50Hz:
1fps / 2fps / 5fps / 10fps / 12.5fps
1
*
Factory settings: 1fps
*
1
When [H.264 transmission] is set to [On], the frame rate may be
slower than the specified value in some cases.
/ 10fps / 15fps / 30fps
1 1 1 1
* * * *
/ 25fps
1 1
* *

Network setup screen [Network]

Configure network settings in the Network setup screen.
The Network setup screen consists of the two tabs of "Network" and
"Advanced".
Network setup screen [Network]
„ z
Click the "Network" tab of the Network setup screen.
The following information is required to configure network settings.
Consult your network administrator or Internet service provider.
• IP address
• Subnet mask
• Default gateway (when using a gateway server or router)
• HTTP port
• DNS primary and secondary server addresses (when using DNS)
86