Multi Screen Setup Screen [Multi-Screen Setup]; Multi-Screen Setup - Panasonic AW-HR140EJ Operating Instructions Manual

Web screen configurations (continued)

Multi screen setup screen [Multi-screen setup]

The cameras whose images are to be displayed on the multi screen are
set here.
IP address
Input here the IP address of the camera whose images are to be
displayed on the multi screen or the host name. With one group
consisting of 4 cameras, up to four groups of cameras (a total of 16
cameras) can be registered.
Input as follows if the HTTP port number of the camera whose images
are to be displayed has been changed.
IPv4 address entry example
IPv6 address entry example
Factory settings:
Cam 1: selfcamera
Cam 2 to Cam 16: Not registered
<NOTE>
• HTTPS cannot be used to connect to the camera whose images are
to be displayed.
• This unit is configured for cameras for which "selfcamera" is
displayed for the IP address or host name.
• When configuring a host name, the DNS settings of the personal
computer that will display the multi screen must be configured.
For details on the personal computer's DNS settings, consult your
network administrator.
192.168.0.10:8080
[2001:db8:0:0:0:0:0:1]:8080
Camera title
Input the camera title here. The camera title which has been input is
displayed on the multi screen.
• You can enter between 0 to 20 half-width characters.
• The following characters can be displayed.
Half-size numeric
characters
Half-size
alphabetical
characters
(upper and lower
cases)
Symbols
Factory settings:
Cam 1: The product number appears.
Cam 2 to Cam 16: blank
<NOTE>
• When a 16-screen multi screen is selected, camera titles may be
only partially displayed.
• Multi screen displays are displayed in 4:3 aspect ratio.
83
0123456789
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
! #$%´() * +,-./:;<=>?@[]^_`{|}˜\