Model Select; Protocol - Panasonic AW-HR140EJ Operating Instructions Manual

Web screen configurations (continued)
OSD Off With Tally
On or off the function that turns off camera menu, status, and other
displays when tally signals are received via commands or contacts.
When the tally signal releases, the camera menu display will return.
Setting value: Off / On
Factory settings: Off
OSD Status
Turn the status display during AWB and ABB on/off.
Setting value: Off / On
Factory settings: Off
DC Out
Turn power supply output from the unit off/on.
Setting value: Off / On
Factory settings: On
z Housing
z
This item's setting is reflected when the [Set] button is pressed.
Fan
Set the cooling fan operation.
Setting value:
Auto Enable automatic control of the cooling fan.
On Turn the cooling fan on.
Factory settings: On
<NOTE>
• Even if this is set to [On], the cooling fan may be forcibly stopped
when the temperature is low.
Heater
Set the heater operation.
Setting value:
Auto Enable automatic control of the heater.
On Turn the heater on.
Factory settings: Auto
<NOTE>
• Even if this is set to [On], the heater may be forcibly stopped when
the temperature is high.
Defroster
Set the defroster device operation.
Setting value:
Auto Enable automatic control of the defroster.
On Turn the defroster on.
Factory settings: Auto
<NOTE>
• Even if this is set to [On], the defroster device may be forcibly
stopped when the temperature is high.
Wiper
Set the wiper operation.
Setting value:
Off Stopped
Fast High-speed operation
Slow Low-speed operation
Factory settings: Off
Washer
Clean the lens by spraying washer fluid on to it.
If you click the [Execute] button, the camera head moves to the
position of the washer nozzle, washer fluid is sprayed for a specific
duration, and the camera head returns to the original position.
The wiper also operates momentarily during cleaning.
z Protocol
z
This item's setting is reflected when the [Set] button is pressed.

Model Select

Set the protocol model for standard serial communication.
Do not select [Reserved1] to [Reserved7].
This is displayed when the MODE switch (→ page 15) on the back
of the unit is set to the 2 or 3 (standard protocol setting) position.
Setting value:
SEVIHD1 / SBRC300 / SBRCZ330 / Reserved1 to 7
Factory settings: SEVIHD1
82