Basic Setup Operations - Panasonic AW-HR140EJ Operating Instructions Manual

Basic setup operations

Camera menus are displayed on the monitor when the unit's settings are
to be selected.
The monitor is connected to the SDI OUT 1/PM connector.
The basic camera menu operations involve displaying sub-menus from
the Top Menu items, and selecting settings on the sub-menus.
Some sub-menus have menu items for performing more detailed
settings.
The camera menu operations are conducted using the controller.
<NOTE>
• Check that your controller is the following version.
AW-RP50: Ver 4.00.00 or later
AW-RP120: Ver 3.00.00 or later
AK-HRP200: Ver 6.00-00-0.00 or later
If the version older, an upgrade is required.
For details on upgrading, visit the support page on the following
website.
http://pro-av.panasonic.net/
Controller operations
„ z
Camera menu operation
Selecting a camera to
Press the <CAMERA STATUS> or <SELECTION> button.
operate
Displaying the Top Menu Press and hold the <CAMERA OSD> button for about 2 seconds.
Selecting items Turn the <F1> dial.
Displaying sub-menus Press the <F1> dial.
Returning to the previous
Place the cursor on [Return], and press the <F1> dial.
menu
1. Press the <F1> dial to make the setting value blink.
2. Turn the <F1> dial to change the setting value.
Changing settings
3. Press the <F1> dial to confirm the setting value (blinking
stops).
Canceling setting
changes
Exiting camera menu
Press and hold the <CAMERA OSD> button for about 2 seconds.
operations
<NOTE>
• Perform the menu operations and exit from the menus using the controller which displayed the Top Menu.
If a menu operation has been performed or a menu has been exited using another controller, first display the Top Menu and exit from it using one
controller, and then display the Top Menu and exit from it using the other controller.
• The procedures used for this unit's menu operations may differ from the ones used for the convertible cameras and HD integrated cameras which
have already been released on the market. For details, refer to the Operating Instructions of the camera concerned.
• The response speed of the camera differs slightly depending on the controller used.
AW-RP50 AW-RP120
―
Described below are the Basic setup operations for changing the
camera menu item settings using the controller (AW-RP50, AW-RP120
or AK-HRP200).
For detailed operations, refer to the operating instructions for
the controller.
Controller
1. Press and hold the <SELECT> button for about 2 seconds.
→ The camera number in the camera number display area
blinks.
2. Press the lit <UP> and <DOWN> button.
→ Press the lit <UP> and <DOWN> buttons to select the
camera number.
3. Press the <SELECT> button.
→ Control of the selected camera is enabled.
Press and hold the <CHARA/MENU> button for about 2
seconds.
Turn the <SELECT> dial.
Press the <SELECT> dial.
Place the cursor on [Return], and press the <SELECT> dial.
1. Press the <SELECT> dial to make the setting value blink.
2. Turn the <SELECT> dial to change the setting value.
3. Press the <SELECT> dial to confirm the setting value
(blinking stops).
Press and hold the <CHARA/MENU> button for about 2
seconds.
30
AK-HRP200
―