Maintenance; Factory Default - Planet GS-4210-16T2S User Manual

4.16 Maintenance

Use the Maintenance menu items to display and configure basic configurations of the Managed Switch. Under maintenance the
following topics are provided to back up, upgrade, save and restore the configuration. This section has the following items:

■ Factory Default

■ Reboot Switch
■ Backup Manager
■ Upgrade Manager
■ Configuration Manager
■ Enable Password
4.16.1 Factory Default
You can reset the configuration of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
to reset the configuration to Factory Defaults.
After the "Factory" button is pressed and rebooted, the system will load the default IP settings as follows:
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
。
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
on the front panel for about 10 seconds. After the device is rebooted, uou can login the management WEB
interface within the same subnet of 192.168.0.xx.
User's Manual of GS-4210-16T2S_24T2S_16P2S_24P2S_48T4S
You can reset the configuration of the switch on this page.
You can restart the switch on this page. After restart, the switch will boot
normally.
You can back up the switch configuration.
You can upgrade the switch configuration.
You can save the switch configuration.
You can set the enable password.
Figure 4-16-1: Factory Default Page Screenshot
386
Figure 4-16-1 appears and clicks
Hardware Reset button