Preparing For Installation - Cisco IW3702 Getting Started Manual

Installation
You can install the access point on a wall, ceiling or pole, in a cabinet or rack, under a seat, or in a plenum airspace. You can direct
mount, DIN rail mount, or attach the access point on a pole mounting bracket.
Perform the installation procedures in this order:
1 Preparing for Installation, on page 14
2 Unpacking the Components, on page 17
3 Mounting the Access Point, on page 19
4 Connecting the Protective Ground and Power, on page 19
5 Connecting the Antennas, on page 22
Connecting to Access Point Ports, on page 23
6

Preparing for Installation

The following topics prepare you for installing the unit:
Warnings
These warnings are translated into several languages in the Regulatory Compliance and Safety Information for the Cisco IW3702
Access Point on Cisco.com.
Danger Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Danger In order to comply with FCC radio frequency (RF) exposure limits, antennas for this product should
be located a minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
Danger Read the installation instructions before you connect the system to its power source. Statement 1004
This unit is intended for installation in restricted access areas. A restricted access area can be
Danger
accessed only through the use of a special tool, lock and key, or other means of security. Statement
1017
Danger This equipment must be grounded. Never defeat the ground conductor or operate the equipment
in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
14