Cisco IW3702 Getting Started Manual page 16

National Restrictions within the European Union
Within the European Union as well as within the majority of the other European Countries, the 2.4 and 5 GHz bands are available
for use by wireless LANs.
The following table provides an overview of the regulatory requirements that are generally applicable for 2.4 and 5 GHz bands.
The requirements for any country might evolve. We recommend that you check with your local authorities for the current status of
regulations for 2.4 and 5 GHz wireless LANs within your country.
Table 3: Overview of Regulatory Requirements for Wireless LANs
Frequency Band (MHz)
2400-2483.5
5150-5350
5470-5725
Tools and Hardware Required
These tools and hardware are required for access point installation:
• Crimping tool (such as Thomas & Bett part number WT2000, ERG-2001, or equivalent)
• 6-gauge copper ground wire
• Wire-stripping tools for stripping 6-gauge wire
• Number 2 Phillips screwdriver
• 1/2" (13 mm) socket for port plug
• 5/8" (16 mm) socket for protective vent
• 5/32" (4 mm) hex key for mounting screws
• Torque wrench (both inch-lbs and ft-lbs)
Installation Guidelines
Because the access point is a radio device, it is susceptible to common causes of interference that can reduce throughput and range.
Follow these guidelines to ensure the best possible performance:
• For information on planning and initially configuring your Cisco Mesh network, refer to the
Design and Deployment
• Review the FCC Guidelines for Installation and Operation of Outdoor Wireless LAN Devices (U-NII devices) Operating in the
5470-5725 MHz Band Data Sheet at:
http://www.cisco.com/c/en/us/products/collateral/routers/3200-series-rugged-integrated-services-routers-isr/data_sheet_c78-647116.html
16
Maximum Power Level
Effective Isotropic Radiated
Power (EIRP) mW
100
200
1000
Guide.
Indoor only
—
x
—
Indoor and Outdoor
x
—
x
Cisco Wireless Mesh Access Points,