Table of Contents
Advertisement
1
Step 4
If necessary, strip the other end of the ground wire and connect it to a reliable earth ground such as a grounding rod or
appropriate ground point on a grounded pole. Length of the ground cable should not exceed 1 meter, and 0.5 meter is
preferred. Use supplied oxide inhibitor on the grounded interface.
Wiring the Access Point DC Power
To wire the access point to a DC power source:
Procedure
Step 1
Verify that the access point is grounded (see
Step 2
Connect the power lead to the PWR connector by turning the cable clockwise, as shown in the following figure.
Ground connection
Grounding the Access Point, on page
19).
21
Hide quick links:
Advertisement
Table of Contents
