Preparing For Installation - Cisco IW3702 Getting Started Manual

Cisco IW3702 Access Point Getting Started Guide
Installation

Preparing for Installation

The following topics prepare you for installing the unit:

Warnings, page 12

EMC Environmental Conditions for Products Installed in the European Union, page 13

National Restrictions within the European Union, page 13

Tools and Hardware Required, page 13

Installation Guidelines, page 13

Site Surveys, page 14
Warnings
These warnings are translated into several languages in the Regulatory Compliance and Safety Information for the Cisco
IW3702 Access Point on Cisco.com.
Warning: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning: In order to comply with FCC radio frequency (RF) exposure limits, antennas for this product should be
located a minimum of 7.9 in. (20 cm) or more from the body of all persons. Statement 332
Warning: Read the installation instructions before you connect the system to its power source. Statement 1004
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning: This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning: Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning: To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: 70°C Statement 1047
Warning: Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning: This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 15 A. Statement 1005
Warning: Do not operate your wireless network device near unshielded blasting caps or in an explosive
environment unless the device has been modified to be especially qualified for such use. Statement 245B
Caution: The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout
force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.
Note: The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National
Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should
not install the power supply or power injector in air handling spaces.
Note: Use only with listed ITE equipment.
12