Ending A Call; Outgoing Calls; Dialing A Number (Pre-Dial); Dialing A Number Directly (Post-Dial) - Avaya 3725 User Manual

3. Click the soft key "Send". The calling party number is displayed in the handset display.
4. Click the soft key "Send". A "Message sent" confirmation is displayed and the message is sent to
the caller.

Ending a call

1. Press On-hook key to end the call.
The duration of the call is shown in the display.
Note:
The total time of the call can also be retrieved from the menu Calls > Call time.
Note:

Outgoing Calls

Dialing a number (Pre-Dial)

Enter the number and press
required, the soft key "Clear" can be pressed to erase the number. By using the navigation key, digits
can be added to or deleted from the middle of a number.
An international number can be dialled from the handset by entering a + character followed by the
country code and local number. To enter the + character, long press the 0 key until the character is
shown in the display.
Note: The + character cannot be entered and international numbers cannot de dialled in the following
circumstances:
If the 0 key has been configured as a hot key.
●
If the handset has been set up to perform advanced functions normally used by a system
●
administrator, as described in
Note: The tone sender in a pre-dialled number can be turned on by long pressing the *-key.

Dialing a number directly (Post-Dial)

1. Press Off-hook key to get the line.
2. Enter the number. Each entered digit is dialed immediately. However, in this case you will not be
able to correct an input error.
Note: The number will not be added to the call list when pre-dial is used.
50
Avaya 3725 DECT Telephone - User Guide
to get the line. The number is shown on the display while dialling. If
Admin menu on page 94.
02/2016