How To Set The Data Boxes - Furuno TZT9 Operator's Manual

1. SYSTEM INTRODUCTION
Select [DATA 1], [DATA 2] or [RADAR] of the side menu at the left of the screen to
show a data box set. To hide a data box set, select [×] at the top right-hand corner of
the data area.
You can select the data to display in each data box on the screen.
1.11.1

How to set the data boxes

How to change the contents of a data box
1. Select the data box to change. The pop-up menu appears.
Select the data box to
change (in this case, COG).
2. Select [Select Data].
3. Select the new data.
How to add a data box to a data area
1. Tap any unoccupied area in the data area to display the pop-up menu.
Tap unoccupied
position.
1-14
◄ Select Data
◄ Cycle Data
Graphic
Remove
The pop-up menu appears.
Go To Informations
Tides & Currents
Radar Gain/Sea/
Bottom Discrim
Date
Position
The pop-up menu appears.