13. How To Adjust Settings; Rotokey Mode - Furuno TZT9 Operator's Manual

13. HOW TO ADJUST SETTINGS

After you understand the basic operation procedures of your equipment, you can set
the equipment according to your needs.
• Set the equipment according to your system configuration.
• Change how the equipment operates and displays information.
All the adjustments are done from the menu. To restore the default settings for the se-
lected menu, select [Reset Default Settings] that is provided on each menu.
Some of the items which you can adjust are as follows:

• RotoKey mode

• System settings
13.1 RotoKey Mode
The user can select how many soft controls to make available with the RotoKey
the chart plotter, weather, radar, sounder, instrument and camera modes. The two
quantities are [Base] and [Full].
The table below shows the soft controls available for use in the chart plotter, weather,
radar, sounder, instrument and camera modes.
Note: The soft controls shown on the screen depend on your system configuration,
equipment settings or functions in current use.
Control label
Level 1
Route
Orientation
Track Rec.
Event
Lat/Lon
3D
Chart
• Data boxes
• Charts
Soft controls available in the chart plotter mode
Level 2
Stop Nav. Stop following a route.
Restart Nav. Restart course.
Skip Wpt Skip a go to point on a route.
North Up Set orientation mode to north up.
Head Up Set orientation mode to head up.
- Record track of your ship.
- Put an event mark.
- Create a point using the software
keyboard.
- Switch the display view from 2D to
3D.
Raster Show raster chart.
S-57 Show S-57 chart.
Jeppesen Show Jeppesen chart.
Navionics Show navionics chart.
Fishing Show fishing chart.
• Units of measurement
Function
TM
in
Base Full
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
13-1