Camera/Video; How To Display A Video Image; How To Set The Video Display; How To Select The Input Source - Furuno TZT9 Operator's Manual

9.

CAMERA/VIDEO

The camera/video function allows you to use your unit to play back images from a vid-
eo player, on-board camera, network camera or DVD player. Network camera images
can be seen across the TZT network. A video signal can be seen only on the TZT that
receives the video signal.
A maximum of four IP cameras can connect to the TZT system and the images from
two can be shown on the display. You can monitor the images from two cameras on
the full screen or the 1/3 screen. You can also set the video application to show the
display of each video in turns. Further, you can also adjust the brightness, contrast
and color of each image.
9.1

How to Display a Video Image

The camera application is included in the default display selection window. Press the
Home key to show the display selection window. Select the camera display to validate
your selection.
9.2

How to Set the Video Display

9.2.1

How to select the input source

Select [Analog 1 (2)] or [IP 1 (2, 3, 4)] from the RotoKey menu to select the input
source.
[Analog 1 (2)]: Video player, on-board camera, or DVD player
[IP 1 (2, 3, 4)]: Network camera
Note: The default menu names are replaced with the nicknames set in the [Initial Set-
up] menu. See the Installation Manual.
Camera
display
9-1