Internal Dual Sd Module (Optional) - Dell PowerEdge R830 Owner's Manual
Hide thumbs
Also See for PowerEdge R830:
- Getting started (8 pages) ,
- Quick start manual (8 pages) ,
- Getting started with your system (8 pages)
Table of Contents
Advertisement
Figure 60. Installing a full-height expansion card into the expansion card riser 3
1.
expansion card holder
3.
expansion card connector
Next steps
1.
If applicable, connect any cables to the expansion card.
2.
Install any device drivers needed for the card as described in the documentation for the card.
3.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing an expansion card from the expansion card riser 3
After working inside your system
Internal dual SD module (optional)
The Internal Dual SD module (IDSDM) provides you with a redundant SD card solution. You can configure the IDSDM for storage or
as the OS boot partition. The IDSDM card offers the following features:
•
Dual card operation — maintains a mirrored configuration by using SD cards in both the slots and provides redundancy.
NOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of System Setup, the
information is replicated from one SD card to another.
•
Single card operation — single card operation is supported, but without redundancy.
118
2.
expansion card
4.
expansion card riser 3
Advertisement
Table of Contents
Troubleshooting
