Internal Dual Sd Module (Optional); Removing An Internal Sd Card - Dell DR4300 System Owner's Manual

5. expansion card riser 3 connector
Next steps
1. Install the expansion card(s) into the expansion card risers 2 or 3.
2. Follow the procedure listed in the After working inside your system section.
3. Install any device drivers required for the card as described in the documentation for the card.

Internal dual SD module (optional)

The Internal Dual SD module (IDSDM) provides you with a redundant SD card solution. You can configure the IDSDM for storage or as the
OS boot partition. The IDSDM card offers the following features:
• Dual card operation — maintains a mirrored configuration by using SD cards in both the slots and provides redundancy.
NOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of System Setup, the
information is replicated from one SD card to another.
• Single card operation — single card operation is supported, but without redundancy.

Removing an internal SD card

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Re-install the SD card(s) into
the corresponding slots.
Steps
Locate the SD card slot on the internal dual SD module and press the card to release it from the slot.
Installing and removing system components 101