Idsdm; Removing The Optional Internal Dual Sd Module - Dell E02B005 Installation And Service Manual

Figure 53. Installing the internal MicroSD card
Next steps
Follow the procedure listed in

IDSDM

Removing the optional internal dual SD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
NOTE: The procedure to remove IDSDM and the BOSS M.2 card is the same.
Steps
1. Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD module (IDSDM) to the system board.
2. Lift the release tab that secures the IDSDM to the system board.
3. Holding both ends of the IDSDM, lift the IDSDM out of the IDSDM/BOSS M.2 connector on the system board.
After working inside your system
Safety instructions
Before working inside your system
on page 46.
on page 45.
on page 45.
Installing and removing system components 89