Installing The Integrated Storage Controller Card - Dell PowerEdge R830 Owner's Manual

Installing the integrated storage controller card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the cooling shroud.
Steps
1. Open the expansion-card latch and remove the filler bracket.
NOTE: Ensure that the H330, H730, H730P, and HBA330 cards are installed only on slot number seven of the
expansion card riser.
2. Holding the card by its edges, align the connector on the card with the connector on the expansion card riser.
3. Insert the card firmly into the expansion card connector until the card is fully seated.
4. Close the expansion card latch.
Figure 43. Installing the integrated storage controller card
1. integrated storage controller card
3. riser 3
5. Connect the SAS data cables to the SAS data cable connectors on the integrated storage controller card.
100
2. expansion card latch
4. SAS cable