Dell PowerEdge R830 Owner's Manual page 99
Hide thumbs
Also See for PowerEdge R830:
- Getting started (8 pages) ,
- Quick start manual (8 pages) ,
- Getting started with your system (8 pages)
Table of Contents
Advertisement
Figure 42. Removing the integrated storage controller card
1.
storage controller card
3.
riser card 3
3.
Disconnect the cables connected to the card by performing the following steps:
a. Press the latch on the SAS cable connector.
b. Pull the SAS cable out of the connector.
4.
If you are removing the expansion card permanently, install the filler bracket.
Next steps
1.
If applicable, install the integrated storage controller card.
NOTE: Ensure that the H330, H730, H730P, or HBA330 card is installed only on slot number seven of the expansion
card riser.
2.
Install the cooling shroud.
3.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing the cooling shroud
Installing the integrated storage controller card
Installing the cooling shroud
After working inside your system
2.
expansion card latch
4.
SAS cable (2)
99
Advertisement
Table of Contents
Troubleshooting
