Figure 84. Cabling diagram—2.5 inch (x8) SAS/SATA backplane
1.
signal connector on the backplane
3.
SAS B connector on the PERC card
5.
system board
7.
signal connector on the system board
9.
hard drive backplane
Next steps
1.
Replace the hard drive backplane.
2.
Install the cooling fan assembly.
3.
Install the cooling shroud.
4.
Install all the hard drives.
5.
Follow the procedure listed in the After working inside your system section.
142
2.
cable retention bracket
4.
SAS A connector on the PERC card
6.
cable retention bracket
8.
SAS B connector on the backplane
10. SAS A connector on the backplane