Ipv6 Application Configuration Example; Ipv6 Applications - 3Com 4200G 12-Port Configuration Manual

Displaying and maintaining IPv6 Telnet
To do...
Display the use information of
the users who have logged in

IPv6 Application Configuration Example

IPv6 Applications

Network requirements
In Figure 2-3, SWA, SWB, and SWC are three switches, among which SWA is a 3com switch 4200G,
SWB and SWC are two switches supporting IPv6 forwarding. In a LAN, there is a Telnet server and a
TFTP server for providing Telnet service and TFTP service to the switch respectively. It is required that
you telnet to the telnet server from SWA and download files from the TFTP server.
Network diagram
Figure 2-3 Network diagram for IPv6 applications
Telnet_Server
3001::2/64
3003::1/64
3003::2/64
SWA
Configuration procedure
You need configure IPv6 address at the switch's and server's interfaces and ensure that the route
between the switch and the server is accessible before the following configuration.
# Ping SWB's IPv6 address from SWA.
<SWA> ping ipv6 3003::1
PING 3003::1 : 64
Reply from 3003::1
bytes=56 Sequence=1 hop limit=64
Reply from 3003::1
Use the command...
display users [ all ]
TFTP_Server
3001::3/64
3001::4/64
3002::1/64
SWC
3002::2/64
SWB
data bytes, press CTRL_C to break
time = 110 ms
2-4
Remarks
Available in any view