Configuring Ntp Server/Client Mode With Authentication - 3Com 4200G 12-Port Configuration Manual

Root dispersion: 208.39 ms
Peer dispersion: 9.63 ms
Reference time: 17:03:32.022 UTC Apr 2 2007 (BF422AE4.05AEA86C)
The output information indicates that Device D is synchronized to Device C, with a clock stratum level of
3, one stratum level lower than that Device C.
# View the information about the NTP sessions of Device D (you can see that a connection is
established between Device D and Device C).
[DeviceD] display ntp-service sessions
source
**************************************************************************
[1234]3.0.1.31
note: 1 source(master),2
associations :

Configuring NTP Server/Client Mode with Authentication

Network requirements
The local clock of Device A is set as the NTP master clock, with a clock stratum level of 2.
Device B is an S4200G Ethernet switch and uses Device A as the NTP server. Device B is set to
work in client mode, while Device A works in server mode automatically.
The NTP authentication function is enabled on Device A and Device B.
Network diagram
Figure 1-10 Network diagram for NTP server/client mode with authentication configuration
Configuration procedure
1) Configure Device B.
# Enter system view.
<DeviceB> system-view
# Set Device A as the NTP server.
[DeviceB] ntp-service unicast-server 1.0.1.11
# Enable the NTP authentication function.
[DeviceB] ntp-service authentication enable
# Configure an MD5 authentication key, with the key ID being 42 and the key being aNiceKey.
[DeviceB] ntp-service authentication-keyid 42 authentication-mode md5 aNiceKey
# Specify the key 42 as a trusted key.
[DeviceB] ntp-service reliable authentication-keyid 42
# Associate the trusted key with the NTP server (Device A).
[DeviceB] ntp-service unicast-server 1.0.1.11 authentication-keyid 42
reference stra reach poll
127.127.1.0
source(peer),3
1
now offset
2 1 64 377
selected,4
1-21
delay disper
26.1 199.53 9.7
candidate,5 configured Total