6. Remove the screws (M6 x2 locations: Fig. 6) fixing the fan motor.
It is recommended that a nutdriver (8mm) be used.
7. Remove the bracket (Fig. 6) and then remove the fan and fan motor (Fig. 7).
8. Loosen the fixed screw with a hexagon wrench (3mm, over 100mm in length) and remove the fan.
5
9. Remove the rubber attached to the wiring of the fan motor (Fig. 9).
Installing Fan Motor
1. For installation, reverse the procedure above.
2. Fine tune so that the fan can be positioned in the center of the fan casing.
5-72
Bracket
Screws (M6)
Fig. 6
Fan motor
Fig. 7
Fixed screw
Fan
Hexagon wrench
Fig. 8
Rubber
Fig. 9