Panasonic S-36PU1E5A Service Manual page 408

1
6-10. Installation of Decorative Panel
When using the wireless remote contoller, follow the step 6-10-3
"When Using Wireless Remote Controller Instead of Wired Remote
Controller" before installing the decorative panel.
6-10-1. Before Installing the Decorative Panel
(1) Remove the air-intake grille and air filter from the decorative panel.
Remove the 2 screws on the latch of the air-intake grille.
(Fig. 1-140) (Reattach the air-intake grille after installation
of the decorative panel.)
6-10-2. Installing the Decorative Panel
The decorative panel has its installation direction. Confirm the direction by displaying the piping side.
(1) Remove the air inlet grille by moving the catchers to center.
Air inlet grille
* Hang the hinge on the hole of decorative panel. (The direction of the installation is free.)
(2) Fitting the decorative panel
Temporarily secure the fixing screws (3 pcs.) before
fitting the decorative panel. (For temporarily securing
the front grille.)
Place decorative panel on the screws (3 pcs.) before
fitting, move decorative panel as illustrated and tighten
all the screws (4 pcs.).
CAUTION
Check before hand the height from the ceiling to the
unit.
The front grille fitting direction is determined by the unit
direction.
Only use the screws with the length of 35 mm which is
provided, to fix the decorative panel.
Do not use other screw which is longer it may cause
damage to the drain-pan and other components.
Catcher
Decorative
panel
Fig. 1-141
Securing the tentative fixing screw
Approx. 20 mm
Decorative
Panel moving
direction
Front grille fixing
screws (4 pcs.)
1-398
Remove the screws with
Phillips head screwdriver.
Fig. 1-140
Hinge
Air inlet grille
Fig. 1-142
Piping
direction
Tighten this
screw first after
hanging the
grille frame
Fig. 1-143