Daikin B-Series Service Manual page 91

Instruction
Outdoor Unit
19
Indoor Unit
1. Air filter
2. Air purifying filter with photocatalytic
deodorizing function:
• These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front grille
5. Grille tab
6. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal operation
and energy saving operation. (page 18.)
7. Display
8. Air outlet
9. Flap (horizontal blade): (page 12.)
10. Louvers (vertical blades):
• The Louvers are inside of the air outlet.
(page 12.)
11. Operation lamp (green)
12. TIMER lamp (yellow): (page 20.)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation. (page 16.)
Outdoor Unit
18. Air inlet: (Back and side)
19. Air outlet
20. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
80
18
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refer to the following table.
• This switch is useful when the remote controller
is missing.
15. Packaging materials: 50 class only
• If any packaging materials are included,
please remove before operating. (page 22.)
16. Room temperature sensor:
• It senses the air temperature around the unit.
17. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
21. Drain hose
22. Earth terminal:
• It is inside of this cover.
20
21
22
Temperature
Mode
setting
FTKS COOL 22°C
FTXS AUTO 25°C
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
Si04-306E
Air flow
rate
AUTO
AUTO
5
Operation Manual