Eng Configuration Page; Engine/Airframe Sensors; Eis Display - Garmin G3X Touch Installation Manual

33.4.19 ENG Configuration Page

The Engine/Airframe Input Configuration section of the Engine Configuration Page allows enabling/
disabling and customization of the engine/airframe input options that make up the EIS display and the
Engine Page on the MFD. The following sections describe configuring items listed in the Engine/Airframe
Input Configuration section of the Engine Configuration page.

33.4.19.1 Engine/Airframe Sensors

Each of the sensors must be correctly installed
being monitored are displayed as gauges on the EIS display (Figure 33-34) and also on the MFD's Engine
Page.
The following list of gauges, (if configured) are specifically required by FAR 91.205 and will always be
displayed on the EIS display (engine bar). Other gauges will be displayed as space permits based on a pre-
defined priority and user selections.
RPM
33.4.19.2 Engine Sensor Installation
NOTE
The following sections contain general guidance on engine and airframe sensor
installation. This information is provided for reference only. The installer should always
follow any installation guidance and instructions provided by the applicable engine,
sensor, or kit-plane manufacturer. Additionally, all installation practices should be done
in accordance with AC 43.13-1B.
Section 29 through Section 32 contain interface drawings for sensor installations using the Garmin sensor
kits, and for other sensor installations.
190-01115-01 G3X/G3X Touch Installation Manual - GDU 37X Config and Post Install Checkout
Rev. AC
(Section
Figure 33-34 EIS Display (Engine Bar)
Oil Temperature
23) and configured prior to use. The Engine inputs
Oil Pressure Fuel Quantity
Page 33-117