Installing The Switch On A Wall - Enterasys 08H20G4-24 Hardware Installation Manual

Mounting the 8 Port Switches
b. Wrap the ends of the strap over the top of the power supply and fasten securely.
c.
7. Plug the power cord from the power supply into the switch DC power receptacle that is
appropriate for your type of power supply.
8. Plug the AC cord into the power supply's AC receptacle.
9. (Optional) Use the wire ties provided to secure the power cords inside the table mounting
tray.
10. Using appropriate screws and the four screw holes in the corner edges of the table mounting
tray, attach the assembled kit underneath your desired table location. Secure the assembled
unit in place by positioning the screw holes over your installed table screws and pulling
slightly forward on the unit.
11. Plug each AC power cord into a dedicated, grounded AC outlet.

Installing the Switch on a Wall

The following section explains how to install the 08G20G2-08 and08G20G2-08P switches on a wall
using the optional D2-WALL-MNT mounting kit.
2-12 Installation
(1) Through the mounting tray clamp beside the power supply.
(2) Under the power supply.
(3) Out through the first mounting hole (closest to the top of the power supply).
(4) In through the second mounting hole.
Repeat this step with another Velcro strap to secure the other end of the power supply to
the mounting tray.
Note: Once assembled, the serial number on the bottom of your switch will be visible through the
window on the bottom of the table mount kit.
Caution: The wall location and wall mounting screws/anchoring method that the installer selects for
mounting the switch must be capable of supporting 55 lbs (25kg).