Figure 2-4 Installing A Switch In The Rack Mount Kit (08G20G2-08P Shown) - Enterasys 08H20G4-24 Hardware Installation Manual

Mounting the 8 Port Switches
Figure 2-4
1 Rear edge of the Switch
To install a switch in the optional rack mount kit, proceed as follows:
1. Mount the switch in the mounting tray by sliding the front edge of the switch underneath the
lip on the mounting tray as shown in
bottom of the switch with the three holes in the rack mounting tray.
2. (Optional) Repeat Step 1 to mount a second switch on the opposite side of the rack mounting
tray.
2-6 Installation
Installing a Switch in the Rack Mount Kit (08G20G2-08P shown)
2 Rack mount tray lip
Figure 2-4, and aligning the three screw holes on the