Garmin G1000 Reference Manual page 52

hazard Avoidance
traffic Advisory system (tAs) (optional)
System Self Test
1) Set the range to 2/6 nm.
2) Select the STANDBY Softkey.
3) Select the TEST Softkey.
4) Self test takes approximately eight seconds to complete. When completed
successfully, traffic symbols are displayed and a voice alert "TAS System Test
OK" is heard. If the self test fails, the system reverts to Standby Mode and
a voice alert "TAS System Test Fail" is heard.
Displaying Traffic on the Traffic Map Page
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the second rectangular page icon.
3) Select the NORMAL Softkey to begin displaying traffic. 'OPERATING' is
displayed in the Traffic Mode field.
4) Select the ALT MODE Softkey to change the altitude volume. Select the
desired altitude volume by pressing the BELOW, NORMAL, ABOVE, or
UNREST (unrestricted) Softkey. The selection is displayed in the Altitude
Mode field.
5) Select the STANDBY Softkey to place the system in the Standby Mode.
'STANDBY' is displayed in the Traffic Mode field.
6) Rotate the Joystick clockwise to display a larger area or rotate counter-
clockwise to display a smaller area.
Displaying Traffic on the Navigation Map
1) Ensure TAS is operating.
2) With the Navigation Map displayed, select the MAP Softkey.
3) Select the TRAFFIC Softkey. Traffic is now displayed on the map.
36
Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
190-00600-02 Rev. A