Connecting The Power Cords; Connecting An Ac Power Cord - HP FlexFabric 5950 Series Installation Manual

Figure 33 Removing the power supply
(1) Pivot the latch to the right with your thumb

Connecting the power cords

WARNING!
Provide a circuit breaker for each power input. When you connect a power cord, make sure the
circuit breaker is switched off.

Connecting an AC power cord

1. Insert the female connector of the AC power cord supplied with the power supply into the power
receptacle on the power supply.
2. Use a cable tie to secure the power cord to the handle of the power supply, as shown in
34.
3. Connect the other end of the power cord to an AC power outlet.
Figure 34 Connecting an AC power cord to the 650W AC power supply
(1) Cable tie
(2) Tighten the cable tie to secure the power cord to the handle of the power supply
2
(2) Pull the power supply out
1
26
1
2
Figure