Rack-Mounting The Router Chassis - Cisco 12410 Installation And Configuration Manual

Chapter 3 Installing the Router
Step 2
Figure 3-11 Removing a Card from the Switch Fabric and Alarm Card Cage
Clock scheduler card
Air filter door
Step 3
Step 4

Rack-Mounting the Router Chassis

OL-11496-01
Starting at slot CSC0:
Pivot the ejector levers to unseat the card from the backplane connector
a.
(Figure 3-11).
Slide the card out of the slot and place it directly into an antistatic bag or other
b.
ESD-preventive container.
Repeat Step 2 for each card.
Close the air filter door and tighten the captive screws to prevent the door from
opening during the chassis installation.
The router chassis can be installed in either a front-mounted position or a
center-mounted position as shown in
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide

Rack-Mounting the Router Chassis

Figure 3-12.
3-17