Prp Console Port Signals - Cisco 12410 Installation And Configuration Manual

PRP Port Connection Guidelines

PRP Console Port Signals

Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
2-36
The PRP console port is a DCE RJ-45 interface for connecting a terminal to the
router. The console port does not support modem control or hardware flow control
and requires a straight-through RJ-45 cable.
Before connecting a terminal to the console port, check the terminal setting for
the data transmission rate, in bits per second (bps). The terminal transmission rate
setting must match the default rate of the PRP console port, which is 9600 bps.
Set the terminal to these operational values: 9600 bps, 8 data bits, no parity, 2 stop
bits (9600 8N2).
Table 2-9 lists the signals used on the console port.
Table 2-9 PRP Console Port Signals
Console Port Pin Signal
1
1 —
2 DTR
3 TxD
4 GND
5 GND
6 RxD
7 DSR
1
8 —
1. These pins are not connected.
Chapter 2
Input/Output Description
— —
Output Data terminal ready
Output Transmit data
— Signal ground
— Signal ground
Input Receive data
Input Data set ready
— —
Preparing for Installation
OL-11496-01