Installing The Chassis In The Rack - Cisco 12410 Installation And Configuration Manual

Chapter 3 Installing the Router

Installing the Chassis in the Rack

OL-11496-01
Two people can lift an empty router chassis using the handles on the sides. To
accommodate racks with different hole patterns in their mounting flanges, the
chassis rack-mounting flanges have three groups of eight oblong screw holes on
each side.
This section describes how to install the chassis in a telco rack.
Figure 3-17 shows the orientation of the chassis to the rack posts.
Figure 3-17 Router and Rack Posts
Front panel
of chassis
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
Rack-Mounting the Router Chassis
Rear panel
of chassis
Rack
Rack-mount bracket
(attached to rack posts)
3-25