Appendix A Technical Specification - Cisco 12410 Installation And Configuration Manual

Appendix A Technical Specifications
Table A-2
Description
Power
Rated input voltage
Rated input line frequency
Input current rating
Source AC service
requirement
Heat dissipation
(total maximum)
Redundancy
1. For each AC power supply module.
To ensure that the chassis configuration complies with the required power
Caution
budgets, use the on-line power calculator. Failure to properly verify the
configuration may result in an unpredictable state if one of the power units fails.
Contact your local sales representative for assistance.
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
OL-11496-01
AC Electrical Specifications
Value
2791 VA (volt-amps) per AC power supply
(2 AC power supplies per system)—original
series
3000 VA (volt-amps) per AC power supply
(2 AC power supplies per system)—original
series
1
200–240 VAC nominal (range: 180 to 264 VAC)
220–240 VAC (UK)
1
50/60 Hz nominal (range: 47 to 63 Hz)
50/60 Hz UK
1
15 A maximum @ 200 VAC
13 A maximum @220 to 240 VRMS (UK)
20 A North America; 16 A international;
1
13 A UK
2800 W@9,544 BTU/hour
2 AC power supply modules required for 2N
redundancy
Router Specifications
A-3