Cutting Work; Towing The Machine; Cutting Operation - Baroness LM2400 Owner's Operating Manual

LM2400
Handling Instructions
6. Slowly depress the traveling pedal.
7. The machine will start to travel.

Towing the Machine

If the machine does not travel due to engine
trouble, etc., you can move it in the following
ways:
Caution
Do not touch the unload valve except when
towing the machine.
Caution
When towing the machine, travel at a speed
no more than 3.0 km/h.
In addition, do not tow the machine for more
than 3 minutes.
If the towing speed is too fast or the machine
is towed too much, the pump or motor will be
damaged.
Caution
Do not loosen the unload valve three turns or
more.
Caution
Before restarting the engine, be sure to
tighten the unload valve.
1. Stop the engine. (See "Procedure to Stop
Engine" (Page 4-20) .)
2. Apply the parking brake and chock the
wheels.
3. Lift up the underseat cover. (See "Underseat
cover" (Page 4-30) .)
4. Loosen the unload valve under the seat 1 to
1.5 turns.
Towing the Machine_001
Page 4-34

Cutting Work

Cutting Operation

1
gay3t1-009
1 Unload valve
5. Remove the wheel stoppers.
6. Depress the brake pedal to release the
parking brake.
7. Tow the machine slowly.
Warning
Do NOT start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it
may damage the hydraulic system or result in
oil leakage.
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
Reel rotation will be turned on or off based on
the sensor-detected position of the mower
units.
Be careful since reel rotation is stopped if the
mower unit up/down lever is moved to the
neutral position or "UP" position.
Shift the reel rotation/stop switching levers of
1.
all mower units to the "Rotate" position.
Start the engine. (See "Procedure to Start
2.
Engine" (Page 4-18) .)
Set the slight lift switch to the "OFF" position.
3.
Note:
Depending on the specifications, this
function may not be available.
4. Raise all mower units, and set the anti-falling
stop valve to the "Stop" position.
5. Engage the mower lock levers (latches) for
mower units #4 and #5.
6. Depress the brake pedal to release the
parking brake.
7. Shift the throttle lever to "High", and rev up
the engine to MAX (3,100 rpm).

Cutting Work