Procedure To Start / Stop Engine; Adjustment Of Cutter Adjustment Spring; Start / Stop Of Engine - Baroness LM2400 Owner's Operating Manual

LM2400
Handling Instructions
2. To decrease cutting height:
[1] Loosen cutting height adjustment nut B,
tighten cutting height adjustment nut A,
then raise the rear roller.
[2] Use the cutting height gauge to
determine the position, then tighten
cutting height adjustment nut B securely.
2
3
A
Roller (Roller Type)_002
1
2
3
4
5
6
7
A

Adjustment of Cutter Adjustment Spring

If the diameter of the reel cutter (cutting cylinder)
becomes smaller, adjust the cutter adjustment
spring.
1. Adjust the blade engagement.
2. Loosen the pipe with cutter adjusting screw,
and then adjust the length of the spring coil
to approximately 40 mm (1.575 in).
Adjustment of Cutter Adjustment Spring_001
1
A
Page 4-18
1
4
9pu8ye-002
Reel cutter (cutting cylinder)
Front roller
Cutting height gauge
Bed knife (Bottom blade)
Cutting height adjustment nut A
Cutting height adjustment nut B
Rear roller
Cutting height
A
1
tv9pml-001
Pipe with cutter adjusting screw
40 mm (1.575 in)

Procedure to Start / Stop Engine

Start / Stop of Engine

Procedure to Start Engine
Warning
Before starting the engine, make sure that
there are no other people or obstacles around
5
the machine.
6
Caution
7
Starter operation must take 15 seconds or
less.
If the engine still does not start, stop using
the battery for 30 to 60 seconds to avoid
exhausting the battery.
1. Open the fuel cock of the sedimenter.
The fuel cock of the sedimenter is located
beside the fuel tank.
2. Open the fuel filter cock.
The fuel filter is located on the left under the
hood.
1
1
B
A
Procedure to Start Engine_001
1 Fuel cock
A ON (Open)
B OFF (Close)
B
A
Procedure to Start Engine_002

Procedure to Start / Stop Engine

v2e27i-013
v2e27i-014