Slight Lift Switch; Reel Reverse Switch; Reel Rotation/Stop Switching Lever; Traveling Pedal - Baroness LM2400 Owner's Operating Manual

LM2400
Handling Instructions

Slight Lift Switch

Note:
Depending on the specifications, this function
may not be available.
Caution
When the mower lock levers (latches) are
engaged, do not operate the mower unit up/
down lever.
The slight lift switch is located in the operation
panel. When the switch is set to the "ON"
position, the mower units are raised only to a
fixed height when the mower units are raised
with the mower unit up/down lever.
1
Slight Lift Switch_001
1
A
B

Reel Reverse Switch

This is located under the hood.
This switches the rotation direction of the reel
cutter (cutting cylinder).
When the reel reverse switch is set to the "ON"
position, the reel cutters (cutting cylinder) rotate
in reverse (back lapping motion). When the reel
reverse switch is set to the "OFF" position, the
reel cutters (cutting cylinder) stop.
1
Reel Reverse Switch_001
Page 4-28
A
B
32w9j9-005
Slight lift switch
ON
OFF
A
B
kp6cmu-001
1 Reel reverse switch
A ON (Rotate)
B OFF (Stop)

Reel Rotation/Stop Switching Lever

Caution
Before operating the reel rotation/stop
switching lever, be sure to shift the reel
rotation lever to the "Stop" position.
The reel rotation/stop switching lever is located
on the reel motor attached to each mower unit. It
is used during cutting and back lapping.
You must shift only the lever(s) for the mower
unit(s) that you plan to use for cutting or back
lapping to the "Rotate" position. Leave the
lever(s) for other mower units in the "Stop"
position.
B
Reel Rotation/Stop Switching Lever_001
1 Reel rotation/stop switching lever
A Rotate
B Stop

Traveling Pedal

Warning
This machine is not authorized as a special
motor vehicle. Do not drive it on public roads.
A
1
2f8equ-002
Operation of Each Section