LM2400
Handling Instructions
12.
Make sure that the charge lamp and oil
pressure lamp turn off.
If they do not turn off, stop the engine and
inspect the machine.
1
Procedure to Start Engine_006
1
2
13.
Shift the throttle lever to the turtle icon (low
speed), and then warm up the engine for
1-2 minutes.
14.
Gradually move the throttle lever to the
rabbit icon (high speed).
Procedure to Stop Engine
1.
Set the traveling pedal to the neutral
position.
2.
Depress the brake pedal and move the
parking brake lock lever forward to lock the
brake.
3.
Set the reel rotation switch to the "Stop"
position.
4.
Shift the throttle lever to the turtle icon (low
speed), and then idle the machine for 1-2
minutes.
5.
Switch the ignition key to the "OFF"
position.
6.
Make sure that the engine has stopped.
7.
Remove the ignition key.
8.
Leave the driver's seat.
9.
Close the fuel cock of the fuel filter.
10.
Close the fuel cock of the sedimenter.
Safety Mechanisms
This machine features a safety device for
starting/stopping the engine.
1.
As for starting the engine, the safety device
prevents the engine from starting unless it
meets each of the following five conditions.
An operator is sitting on the seat.
・
Page 4-20
2
v2e27i-017
Charge lamp
Oil pressure lamp
The parking brake is applied.
・
The mower unit up/down lever is moved to
・
the neutral position.
The traveling pedal is set to the neutral
・
position.
The reel rotation switch is set to the "Stop"
・
position.
2.
In the event the operator leaves the seat with
the parking brake applied and the engine
running, the safety device will be activated
and will stop the engine under any of the
following conditions:
・
The traveling pedal is not set to the neutral
position. (The operator has depressed the
traveling pedal.)
・
The reel rotation switch is set to the
"Rotate" position.
・
The mower unit up/down lever is moved to
the "DOWN" position.
Warning Mechanisms
This machine features warning mechanisms for
overheating and for the hydraulic oil level.
1.
If water temperature inside the engine
exceeds 105 degrees Celsius, a buzzer will
sound. (intermittent tone)
2.
If the oil level in the hydraulic tank declines
from the specified level by approximately 4.2
3
dm
(4.2 L), a buzzer will sound. (intermittent
tone)
Operation of Each Section
Precautions for Operating the Machine
Caution
Under any circumstances drive the machine
at such a speed that you can stop it
immediately for emergencies.
Cautions for when You Leave the
Machine
Caution
If the brakes are not sufficiently effective, use
the wheel stoppers to secure the machine.
Operation of Each Section