Alfa Romeo 4C spider User Manual page 162

4. Turn the Rotary encoder to select either OFF or
ON (Initial setting) and press
5. Press and hold AUDIO/SETUP for at least two
seconds to return to normal mode.
Setting The Bluetooth Device
Select one of 5 connected Bluetooth compatible
devices that you previously registered.
• Setting item: Paired Device
1. Press and hold AUDIO/SETUP for at least two
seconds to activate the SETUP mode.
2. Turn the Rotary encoder to select "Bluetooth",
and then press /ENTER.
3. Turn the Rotary encoder to select Paired De-
vice and then press /ENTER.
4. Turn the Rotary encoder to select a Bluetooth
compatible device you want to use (you
want to change connection) and then
press /ENTER.
160
5. Turn the Rotary encoder to select "Connect" to
/ENTER. connect the selected device.
The connected device is marked with
Select "Disconnect" to disconnect this de-
vice. Select "Clear" when you want to clear
the device from the device list.
6. Press and hold AUDIO/SETUP for at least two
seconds to return to normal mode.
NOTE:
• If the connection is successfully changed,"Con-
nected" is displayed for two seconds and the
indicator lights up, then the display returns
to the SETUP screen.
• If a Smartphone is connected to this unit suc-
cessfully, the
battery charge of the connected Smartphone.
The indicator lights up when the battery
charge is about 50%, the
up when the battery charge is not enough, and
it blinks as a low level warning. The
tor goes out when the battery is drained. At this
time, the Bluetooth function is unavailable due
to the Smartphone powered off.
• Indicator
.
• Depending on the connected Smartphone, the
• If all the three positions have been registered,
Setting The Visible Mode
You can set whether this unit can be recognized or
not from a Bluetooth compatible device. Normally
set this to ON.
indicator lights up to show the
• Setting item:
OFF:
indicator lights
Disable recognition of this unit from the Bluetooth
compatible device.
indica-
(Signal Strength) will display the
current signal strength of your service provider.
The indicator goes out when the Smart-
phone is not in service area or receives no
signal.
(battery charge), and (signal strength)
indicators may not be displayed.
you cannot register the 4th device. To register
another device, you need to delete one of the
devices from position one to three first.