The Printing Position Is Skewed
Perform one of the following solutions according to the cause.
<Cause 1> [Gutter] is specified.
Solution
<Cause 2> [Offset Y] and [Offset X] are specified.
Solution
<Cause 3> "Top Margin" and "Paper Position" in the application are not specified properly.
Solution
<Cause 4> The printing position is adjusted in [Adj. Start Position].
Solution
Downloaded from ManualsPrinter.com Manuals
Downloaded from
www.Manualslib.com
Perform the following procedure in the printer driver.
1. Display the [Finishing] sheet.
2. Click [Gutter].
3. Set [Gutter] to "0."
You can specify the same setting from the printer's control panel.
"[Setup] Menu ([Layout] Options)"
Set [Offset Y] and [Offset X] to "0."
"Adjusting the Printing Position for All the Jobs"
Specify the settings for "Top Margin" and "Paper Position" in the application properly.
See the instruction manual supplied with the application.
Adjust the printing position to an appropriate value in [Adj. Start Position].
"Adjusting the Printing Position for Each Paper Source"
manuals search engine
04L9-0LE