Canon LBP6680x E-Manual page 574

[SNMP v. 3
Settings]
[Rjct Packet in
Sleep]
*
[Spooler]
[Network Delay
Time]
[Remote UI
Settings]
[Ethernet Driver]
[IEEE802.1X]
[Address Filter]
[MAC Address]
[E-Mail Print Set.]
[Init. Network Set.]
Downloaded from ManualsPrinter.com Manuals
Downloaded from www.Manualslib.com
[Off],
[Read/Write],
[Read Only]
[SNMP v. 3]: [Off],
[On]
[User Settings 1] to
*
[User Settings 5] :
[Auth. Password]
[Encryption
Password]
[Off], [On]
[Off], [On]
0 to 300 seconds
[Remote UI]: [Off],
[On]
*
[SSL] : [Off],
*
[On]
[Auto Detect]:
[Off], [On]
[Communication
*
Mode] : [Half
Duplex], [Full
Duplex]
*
[Ethernet Type] :
[10 Base-T],
[100 Base-TX],
[1000 Base-T]
[Off], [On]
[Off], [On]
(Display only)
[POP3 RX Interval]: 0
to 90 (minutes)
[POP3 RX]: [Off], [On]
[SMTP RX]: [Off],
[On]
manuals search engine
Base (MIB) of the community (canon_user) that SNMP
manages.
Specify the settings related to SNMP v. 3 protocol.
Specifies whether to discard the SNMP packets received while in
sleep mode.
If you set this item to [On], you may be unable to access the
printer from Canon software (iW Series) or applications using
the SNMP protocol.
When using the spooling function, set it to [On].
"Setting the Spooling Function (LBP6680x Only)"
Specifies the time interval from when the printer is turned ON to
when the protocol starts.
"Specifying the Setting for Startup Waiting Time"
Specifies whether the printer should use the Remote UI.
Also, whether to use SSL for communication by the Remote UI is
specified.
"Setting Keys and Certificates"
Configures the Ethernet driver.
"Changing the Network Transmission Speed or Transfer Mode"
When using the IEEE802.1X function, set it to [On].
"Setting IEEE802.1X Authentication"
When using the address filter function, set it to [On].
"Restricting the Users Who Can Print or Perform the Printer
Settings"
"Restricting the Users Who Can Access"
Displays the MAC address of the printer.
Set e-mail print.
When [POP3 RX Interval] is changed from 0 minute, POP3
reception immediately after the setting has been changed is
performed at a specified interval plus approximately five
seconds. From the second time onwards, POP3 reception is
performed at a specified interval.
"Receiving E-mail Data on the Mail Server and Printing (E-mail
Print)"
By the initialization in this item, you can reset the network settings to
the default settings.
"Initializing the Network Settings"