Vista QTVI08L Installation And User Manual page 37

Change the priority listing to suit the schedule requirements. Each priority level can be
selected to be any of the following:
Alarm, Motion, Normal Time Lapse (1 -4) or None
The record mode at the top of the list is the one that takes priority.
In the example above Alarms will take priority to over all else. So when an alarm input is
triggered the record setting for that input will be used.
If there are no active alarm inputs, then the DVR is looking for cameras with motion in the
scene, when motion is detected then the Motion Record settings will be used.
If there are no active alarm inputs and no motion is detected, the DVR will record using
the Normal Time Lapse 1 settings.
2) Using the remote controller
Setting of the schedule profiles can be carries out using the remote controller, referring to
the images in the previous section use the following button presses.
Press the SEL button to enter the Schedule set up screen.
Select the box next to the Profile using the Up/Down/Left/Right button to display the
priority settings and press the SEL button.
Select the priority number using the Up/Down button and press the SEL button.
Change the priority settings using the Up/Down button and press the SEL button.
Press the Down button to move to OK and press the SEL button to confirm the changes.
[Change the priority listing]
1) Using the mouse
Once the priority settings for all the require profiles have been set, then the timetable can
be programmed for the periods during which each profile is to be used.
To select the hours of the week that each profile is to be used, click in the tick box for that
profile, then click drag on period within the timetable. The Profile number will appear in
the selected boxes, as shown in the next table.
Click the "Apply" to save and exit.
2) Using the remote controller
Select one of the profiles using the Up/Down button and press the SEL button.
Navigate to required hour on the time table using the Left/Right/Up/Down button.
Press the SEL button to change the profile number.
Press the MENU button to confirm and exit.
QTVI Manual V2.0
QTVI installation and user manual
37