Parking Aids; Principle Of Operation; Using The Parking Aid - Ford FUSION 2011 Owner's Manual

Hide thumbs Also See for FUSION 2011:
Table of Contents

Advertisement

PRINCIPLE OF OPERATION

WARNING
The parking aid does not relieve you
of your responsibility to drive with
due care and attention.
CAUTIONS
Vehicles fitted with a trailer tow
module not approved by us may not
correctly detect obstacles.
The sensors may not detect objects
in heavy rain or other conditions that
cause disruptive reflections.
The sensors may not detect objects
with surfaces that absorb ultrasonic
waves.
The parking aid does not detect
obstacles moving away from the
vehicle. They will only be detected
shortly after they start to move towards
the vehicle again.
Take particular care when reversing
with a tow ball arm or rear fitted
accessories e.g. a bicycle carrier, as
the rear parking aid will only indicate the
distance from the bumper to the obstacle.
If you use a high pressure spray to
wash your vehicle, only spray the
sensors briefly from a distance not
less than 20 centimetres (8 inches).
Note: On vehicles fitted with a tow ball
arm, the parking aid is deactivated
automatically when any trailer lamps (or
lighting boards) are connected to the 13-pin
socket via a trailer tow module we have
approved.
Note: Keep the sensors free from dirt, ice
and snow. Do not clean with sharp objects.

Parking Aids

Note: The parking aid may emit false tones
if it detects a signal using the same
frequency as the sensors or if the vehicle is
fully laden.
Note: The outer sensors may detect the
side walls of a garage. If the distance
between the outer sensor and the side wall
remains constant for three seconds, the
tone will switch off. As you continue, the
inner sensors will detect rearward objects.

USING THE PARKING AID

Switching the parking aid on and
off
Note: The parking aid switches off
automatically when you start the engine or
when you exceed 16 km/h (10 mph).
Note: The front and rear sensors are always
activated or deactivated together.
The parking aid is per default off. To switch
the parking aid on, press the switch in the
instrument panel or select reverse gear.
The light in the switch illuminates when
the parking aid is activated.
To turn it off, press the switch again.
Manoeuvring with the parking aid
E72902
Note: If a high pitch warning tone sounds
for three seconds and the light in the switch
is flashing, it indicates a malfunction. The
system will be disabled. Have the system
checked by properly trained technicians.
84

Advertisement

Table of Contents
loading

Table of Contents