Table of Contents
Advertisement
Vehicles with a petrol engine
CAUTIONS
Do not connect to the negative (–)
terminal of the flat battery.
Make sure that the jump leads are
clear of any moving parts.
1.
Position the vehicles so that they do
not touch one another.
2. Switch off the engine and any electrical
equipment.
3. Connect the positive (+) terminal of
vehicle A with the positive (+) terminal
of vehicle B (cable C).
4. Connect the negative (-) terminal of
vehicle B to the engine block or engine
mount of vehicle A (cable D), as far
from the battery as possible.
Vehicles with a diesel engine
CAUTIONS
Do not connect to the negative (–)
terminal of the flat battery.
Make sure that the jump leads are
clear of any moving parts.
1.
Position the vehicles so that they do
not touch one another.
2. Switch off the engine and any electrical
equipment.
3. Connect the positive (+) terminal of
vehicle A with the positive (+) terminal
of vehicle B (cable C).
4. Connect the negative (-) terminal of
vehicle B to the turbocharger of vehicle
A (cable D).
To start the engine
1.
Run the engine of vehicle B at
moderately high speed.
2. Start the engine of vehicle A.
Vehicle battery
3. Run both vehicles for a minimum of
three minutes before disconnecting the
leads.
Disconnect the cables in the reverse order.
115
CAUTION
Do not switch on the headlamps when
disconnecting the cables. The peak
voltage could blow the bulbs.
Advertisement
Table of Contents
