Table of Contents
Advertisement
When traffic information is broadcast, it
will automatically interrupt normal radio,
tape or CD playback and TRAFFIC or
NEWS will be shown in the display.
If the traffic signal weakens, TP will flash
in the display. Press the seek up or seek
down button (the left or right navigation
button on Sony or Sony DAB audio units)
to find another station.
Note: If this happens during CD or AUX
playback or, on certain models, with the
radio volume set to zero, the unit will retune
automatically if the station is not available.
If a non-traffic station is selected or
recalled using a preset button, the audio
unit will remain on that station unless TA
is turned off, then on again.
Note: If TA is on and you select a preset or
manual tune to a non TA station no traffic
announcement will be heard.
Local or distant traffic
The number of RDS or EON traffic
announcements may become excessive
in some areas so there is an option to
select between local traffic information
and all available information.
6000CD and 6006CDC
1.
Press and hold the MENU button until
the display changes.
2. Press the MENU button repeatedly
until TA is shown in the display.
3. Press the seek up or seek down button
to select either local (TA LOCAL) or
distant (TA DIST) traffic
announcements.
4. Press the MENU button or allow the
menu to time out to confirm your
selection.
Note: Either TA-L or TA-D will be shown in
the display.
Audio unit operation
Sony CD
1.
2. Press the left or right navigation button
3. Press the MENU button to confirm
Traffic announcement volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume
6000CD and 6006CDC
1.
2. Rotate the volume control to make the
Note: The selected level will be shown in
the display.
Sony CD
1.
2. Press the left or right navigation button
Note: The selected level will be shown in
the display.
Ending traffic announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA during the
announcement.
Note: If you press TA at any other time it
will switch all announcements off.
142
Press the MENU button and use the
up or down navigation button to select
the TA display.
to select your required setting.
your selection.
Press and hold the TA button.
necessary adjustment.
Press and hold the TA button.
to make the necessary adjustment.
Advertisement
Table of Contents
