Table of Contents
Advertisement
Note: Contamination with dirt, water,
petroleum products or other materials may
result in brake failure or costly repairs.
Note: The brake and the clutch systems are
supplied from the same reservoir.
Top up with fluid that meets the Ford
specification. See Technical
Specifications (page 109).
TECHNICAL SPECIFICATIONS
Vehicle fluids
Item
Engine oil
Power steering fluid
Antifreeze
Brake fluid
*
Providing it meets the specification defined by WSS-M2C913-C, you can also use Ford
Engine Oil or an alternative engine oil.
Topping up the oil: If you are unable to find an oil that meets the specification defined
by WSS-M2C913-C, you must use SAE 5W-30 (preferred), SAE 5W-40 (except vehicles
with E85 fuel) or SAE 10W-40 that meets the specification defined by either ACEA
A5/B5 (preferred) or ACEA A3/B3. Using these oils can result in longer engine cranking
periods, reduced engine performance, reduced fuel economy and increased emission
levels.
Do not use oils which do not meet the specifications or requirements. Use of
unsuitable oil may lead to engine damage which is not covered by the Ford Warranty.
Note: If you operate your vehicle in temperatures below -20°C (68°F), you must not use
SAE 10W-40 engine oil.
Castrol engine oil recommended.
Maintenance
WASHER FLUID CHECK
Note: The front and rear washer systems
are supplied from the same reservoir.
When topping up, use a mixture of washer
fluid and water to help prevent freezing in
cold weather and improve the cleaning
capability. We recommend that you use
only high quality washer fluid.
For information on fluid dilution, refer to
the product instructions.
Specification
WSS-M2C913-C
WSS-M2C204-A2
WSS-M97B44-D
WSS-M6C57-A2
CAUTION
109
Recommended fluid
*
Castrol Engine Oil
Ford or Motorcraft Power
Steering Fluid
Motorcraft SuperPlus Anti-
freeze
Ford or Motorcraft Super
DOT 4 Brake Fluid
Advertisement
Table of Contents
