Starting A Diesel Engine - Ford FUSION 2011 Owner's Manual

Hide thumbs Also See for FUSION 2011:
Table of Contents

Advertisement

Starting and Stopping the Engine
If the engine does not start after three
attempts, wait 10 seconds and follow the
Flooded engine procedure.
If you have difficulty starting the engine
when the temperature is below -25°C
(-13°F), press the accelerator pedal
between ¼ to ½ of its travel and try again.
Flooded engine
Vehicles with manual transmission
1.
Fully depress the clutch pedal.
2. Fully depress the accelerator pedal and
hold it there.
3. Start the engine.
Vehicles with automatic transmission
1.
Select park or neutral.
2. Fully depress the accelerator pedal and
hold it there.
3. Fully depress the brake pedal.
4. Start the engine.
All vehicles
If the engine does not start, repeat the
Cold or hot engine procedure.
Engine idle speed after starting
The speed at which the engine idles
immediately after starting will vary
depending on the engine temperature.
If the engine is cold then the idle speed will
automatically be increased in order to heat
the catalytic converter as quickly as
possible. This makes sure that vehicle
emissions are kept to an absolute
minimum.
The idle speed will slowly decrease to the
normal level as the catalytic converter
warms up.

STARTING A DIESEL ENGINE

Cold or hot engine
All vehicles
Note: When the temperature is below -15°C
(5°F), you may need to crank the engine for
up to 25 seconds. If you consistently operate
the vehicle in such temperatures, we
recommend that you have an engine block
heater fitted.
Note: Continue cranking the engine until it
starts.
Note: You can only operate the starter for
a maximum of 30 seconds at a time.
Switch the ignition on and wait
until the glow plug indicator goes
off.
Vehicles with manual transmission
Note: Do not touch the accelerator pedal.
1.
Fully depress the clutch pedal.
2. Start the engine.
3. If the engine does not start, fully
depress the brake and clutch pedals
and try again.
Vehicles with automatic transmission
1.
Select park or neutral.
2. Fully depress the brake pedal.
3. Start the engine.
73

Advertisement

Table of Contents
loading

Table of Contents