11 ] Removing The Sensor Holder B, T Sensor Pcb Assy, And Sensor Cover C - Brother TD-2020 Service Manual

[ 11 ] Removing the Sensor Holder B, T Sensor PCB ASSY, and Sensor Cover C

(1) Turn over the roll cover inner.
(2) Remove the two taptite bind B M2.6X8 screws, and remove the sensor holder B
from the roll cover inner. Pull out the harness of T sensor PCB ASSY from the
hole of the roll cover inner.
(3) Remove the T sensor PCB ASSY from the sensor holder B.
(4) Remove the two double face tapes TD2000 from the T sensor PCB ASSY.
(5) Remove the sensor cover C from the sensor holder B.
Sensor holder B
Double face tapes TD2000
T sensor PCB ASSY
Roll cover inner
Taptite bind B M2.6X8
Figure 3.4-15
III - 17
Sensor cover C
Hole