[ 9 ] Attaching the Release Lever ASSY and Tear Bar
(1) Engage edge of the release spring to the hole of the shaft bushing of the roll
cover inner, and set the release lever ASSY to the two shaft bushings.
NOTE: Be careful not to scratch roll cover inner with the edge of the release
spring.
(2) Set the tear bar cap to the tear bar. Attach the tear bar to the roll cover inner with
two taptite bind B M2.6X6 screws.
Shaft bushing
Taptite bind B
M2.6X6
Tear bar cap
Release lever ASSY
Release spring
Tear bar
Figure 3.5-11
III - 36
Edge
Shaft bushing
Roll cover inner