Assembly Procedure; 1 ] Assembling The Mecha Assy - Brother TD-2020 Service Manual

3.5 ASSEMBLY PROCEDURE

[ 1 ] Assembling the Mecha ASSY

(1) Attach the front cover B to the sub plate with the two screw bind M3X4 screws.
(2) Attach the platen bushing R to the main chassis R with the screw bind M2X3 screw.
NOTE: When tightening the screw, push the platen bushing R in the direction of the
(3) Attach the main chassis R to the sub plate with the two screw bind M3X4 screws.
(4) Attach the platen bushing L to the main chassis ASSY with the screw bind M2X3
screw.
NOTE: When tightening the screw, push the platen bushing L in the direction of the
(5) Insert the platen roller shaft (non D-cut surface) into the platen bushing R.
(6) Attach the main chassis ASSY to the sub plate with the two screw bind M3X4 screws.
(7) Stick filament tape (W: 9mm X L: 35 ± 5mm) to the main chassis ASSY and main
chassis R.
NOTE: Stick the filament tape so that it covers the frame edge.
Screw bind M3X4
Main chassis
ASSY
Screw bind M3X4
arrow A to reduce rattle.
arrow B to reduce rattle.
Platen bushing L
B
Front cover B
D cutout surface
Platen roller
Screw bind
M2X3
Filament tape
Sub plate
Screw bind M3X4
Figure 3.5-1
III - 26
Platen bushing R
A
Main chassis R
Filament
tape