Inspection Outline - Brother TD-2020 Service Manual

1.2.2 Inspection Outline

When you start the tool and implement "Read serial no", the next available inspection, "Write
default eeprom data", becomes operable after completion of the inspection. All the listed
inspections will be completed by operating in descending order. Inspections after "Check
adaptor AD" are optional. They can be omitted when the operation has been already checked or
the inspection is unnecessary. However, be sure to implement "Write serial no" as the last item.
Note : Serial number will not be written into the machine unless "Write serial no" is completed.
Inspection list ("O": valid "-": invalid)
Name of inspection
Read serial no
Check MAC address
Write default eeprom data
Write media information
Write product info
Write mass storage info
Write pincode and localname
Adjust transmission sensor
Adjust reflecting sensor
Reboot printer
Print test(Label)
Check adaptor AD
Check USB host
Check connect TDU
Check peel sensor (Paper none)
Check peel sensor (Paper on)
Check battery AD
Check holder adaptor AD
Check battery charge
Check LED
Write smart info
Write serial no
*1 Only for TD-2130N. This setting applies only to HC models.
Operation procedures for each inspection item are explained in the following pages.
Procedures can be different between TD-2000 and TD-2100N. Follow the instructions for each
model explained hereafter.
Communication
2000
I/F
USB O
USB -
USB O
USB O
USB O
USB O
USB -
USB O
USB O
USB O
USB O
USB O
USB -
USB -
USB -
USB -
USB -
USB -
USB -
USB O
USB -
RS-232C O
1 - 3
2100N Note
O
O
O
O
O
O
O
O
O
O
O
O
O
O Optional touch panel display unit
connection is required.
O Optional peeler connection is
required.
O Optional peeler connection is
required.
O Optional battery base unit and
battery are required for power
supply.
O Optional battery base unit and
adapter are required for power
supply.
O Optional battery base unit,
battery and adapter are required
for power supply.
O
*1
O Always operate as the last
inspection item.